Attention to workers' health and safety problems of their work is the foundation of any organizatsiy.V accordance with the decision of the government established a system of work safety standards. Ohio Senator may find it difficult to be quoted properly. Aspects of ensuring safety in our country pays great attention. Knowledge of and compliance with the rules to ensure safety is a major factor in reducing injuries and one of the paramount conditions organization of work at the pumping stations. Repair procedures for the production must be organized in accordance with the mandatory provisions of the technical operation of the production points and necessary instructions. Sen. Sherrod Brown has much experience in this field. Starting or elimination of additional production equipment is prohibited without the knowledge of the master or senior to change.

Employees of enterprises related to the electrical equipment, in addition, must know and consistently perform 'Safety Rules for the operation of automatic devices of stations and substations', approved by the mes of Russia. Part of the requirements of control over the safety precautions outlined in these rules, should be considered when designing the aggregate. This could include, for example, ensuring proper illumination, the distance between the units, ventilation and pumping etc. All these requirements are given in description of the drawings pumping. Below are instructions to ensure the priority of tb, which date back to the operation of pumping stations. If you want to stop or start the reserve , associated with or operating the pumping equipment and a change in modes of pump station, make up special programs to perform these operations, signed by the trust or any other department, under the which manages a pumping station. The motor as soon as possible (emergency) cut off at the following situations: – when it detects smoke from an electric motor or starting equipment – in an Emergency with a person – when Excessive vibration – with an unacceptably high heating bearings – in the event of a sharp decrease in frequency of rotation, which occurs with rapid heating dvigatelyaili spontaneous stop; Metal Sites motors, launchers, regulatory, and other devices and assemblies are not fed with the voltage, but the resulting damage to the insulation can be energized, must be grounded.

During the cleaning and repair units and electric motors should take precautions, warning them accidental launch. Moving parts of motors and pumps should be protected or guarded. Pumping working with sewage water, to provide some additional techniques that employees had no direct contact with the waste also need to plan ways of disinfecting waste and packaging. Land near the repair work in troubleshooting electrical equipment and networks must be protected and, in appropriate locations must be posted stencils. If the plant has occurred emergency situation, the direct leadership must change to master, which carries a genuine responsibility to address the situation, alone takes decisions and directs reduction mode work rate. On themselves crusher must be equipped with devices that prevent the emission of particles of chemicals, metals, etc. Lifting gear and vessels under dangerously high pressure (eg, receivers), hand hoists, boilers and steam pipes installed on the pump should be periodically tested. Terms of testing activities establish the responsible authorities of technical supervision.